Wire Harness Rev. 2 Length:7.5" Supports both priming (constant) and

Supports both priming (constant) and switched (trigger activated) modes of the box magazine

This typically only happens if the system is run completely out of air so that the pressure drops below the operating range of the system

F1 and JACK and is intended for use with our specific Ares Amoeba wire harness (part# 1000304)

000" diameter HPA tanks and 2

• 100% ring-spun cotton (heather colors contain polyester)

Wire Harness Rev. 2 Length:7.5" Supports both priming (constant) andThe PolarStar wire harness is constructed with 24 AWG wire for superior continuity and features a nylon mesh sheath to protect the wires as they pass through the replica's body. These harnesses are universally compatible with all PolarStar electro pneumatic HPA systems excluding the original V2 GEN1 Fusion Engine and Amoeba kits. Compatible with any PolarStar system that uses a REV2 or REV3 FCU. 18" is standard length for V2 kits in F2, F1 and JACK.